Problems that should be paid attention to when using can sealing machine

The problems that should be paid attention to when using the sealing machine:

1. Each turn of the sealing carousel has 12 stations (that is, 12 equal parts). The splitter parameters, deceleration and parameters listed in the purchased parts list are for reference only, because they need to be determined according to the output per minute required by the user.

Sealing machine 2. There is always a certain amount of butter (molybdenum disulfide grease) in the gear box.

3. Refuel the buttermouth American class once.

Sealing machine 4. Each radial bearing (headed by 6) should have oil seals on both sides. Power cord factory

Sealing machine 5. The round pin φ8 of part number 24# should be pressed in, and then thin spring steel sheet z (thickness d = 0.5 ± 0.02 after surface grinder is used to adjust the gap between d = 0.03-0.05) , And often add oil for lubrication.

6. Before installing needle roller bearings and cylindrical roller bearings, lubricate each ring.

Sealing machine 7. Part No. 41# Plane bearings should also be greased during use.

8. The shape and structure of the sealing roller and roller shaft are for reference only.

Sealing machine 9. The turntable material is hard plastic in South Korea, bakelite or aluminum alloy plate is used in the world. The requirement is that it is not magnetic, the other is easy to process and maintain accuracy, and the third is not deformed. Please choose reasonably.

10. For jars of different diameters, turntables and pressure heads with different positioning arcs are used. Fryer

11. The automation and coordination of electrical appliances, segmentation, indexing, and cylinder production are controlled by plc and designed by electrical engineers.

12. An additional conveyor belt without motor is used for emptying the tank at the inlet side, about 2mm long.

13. The guard and door can be made according to the base and referring to the video.

14. The part number 112# turntable dead-point electronic photoreceptor assembly, can be installed on the workbench below the turntable empty to install the induction photoelectric tube, or you can refer to this general drawing or video to make a seat installation, which is determined by the electrical engineer.